This tab screen is accessed from the Additional Design Properties toolbar button on the Design CAD Tab . This tab screen is accessed from the Additional Design Properties toolbar button on the Design CAD Tab .
Other Available Tabs
Design Additional Properties Tab Screen
Variable Rib Spacing Tab
This tab is used to alter the sweep back of a Wing or Tail design.
To alter the sweep angle;
Enter a value for the % chord position to apply the sweep angle. For example to have a 30 degree sweep back measured from the leading edge, enter 0.
Enter the sweep angle in degrees. To have sweep back enter a positive value. To have sweep forward enter a negative value.
Click on the Update button to update the value in the Design CAD Tab .
To make the change permanent, click on the Save toolbar button in the Design CAD Tab .